|
|
|
|
|
|
Posted: Fri May 08, 2015 8:09 pm
|
|
|
|
|
|
|
Posted: Fri May 08, 2015 8:11 pm
|
|
|
|
|
|
|
|
|
Posted: Fri May 08, 2015 8:11 pm
|
|
|
|
Italy's Curl (from Hetalia):
What you need: -un-styled bronze/copper wig -a 12" strip of wire (About as thick as three paper clips) -Clear nail polish -Hot glue -Needle and thread
So when buyin a wig, make sure it is alittle more thick then the character's hair, so when you go to thin it in the back, you can collect the strands that you cut off.
Now first things first~ Bend the wire so that it makes the curl at one end, and a .5 in "L" shape at the other end. Now comes the hard part~ putting on the hair. so You start at the tip of the curl end on the wire, add just a dot of hot glue and start gluing all around the tip of the wire. DO NOT touch the glue while it is drying! This will make the glue un-noticable! and continue to put dabs of glue till the hairs sticks to the wire without poking out too much! Once you get the hair around the surface of the wire, you can start to brush the clear nail polish on the hair so that it sticks to itself, the other hairs, and the wire. You do this til you reach the "L" shape at the other end of the wire.
Now you glue the "L" shape part of the wire on one of the strips on the inside of your wig, you will also sew it in, and add more glue till it stays. (shouldnt take too much)
The curl should survive through the whole con, and should just need another layer of Polish to take away the stray hairs n-n
Here is another way to do it: [Curl Tutorial]
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Posted: Fri May 08, 2015 8:13 pm
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|